Now you can pull the keyboard cable from the connector. The retainer will open up at a 90 degree angle. On this picture the keyboard connector shown in the LOCKED state.Ĭarefully lift up the left side of the cable retainer (brown piece) with your fingernail. In the following two steps I explain how to unlock the connector. ![]() Remove the screwdriver and continue removing the keyboard with your fingers.īefore you remove the keyboard you’ll have to disconnect the keyboard cable from the motherboard. The top side of the keyboard will lift up a little bit and you should be able to insert your fingers under the keyboard. Very genteelly push the screwdriver into the hole on the bottom of the laptop. A small slotted screwdriver should work too. I’m using a T6 torx screwdriver for that because it has a flat end. NOTE: you’ll be pushing on the bottom side of the keyboard so don’t use a sharp screwdriver. Insert a small screwdriver into the hole. In order to remove the keyboard you’ll have to use the hole located on the left side from the wireless card. ![]() Pull the DVD drive to the right and remove it. Upgrading this regular 2.5″ SATA hard drive to a 2.5″ SATA solid state drive will improve laptop performance significantly. Lift up and remove the hard drive assembly. Unplug the hard drive cable from the motherboard. ![]() Remove four screws securing the hard drive assembly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |